Rust Guard Metal Primer(Water based)

PRODUCT DESCRIPTION

The new generation water based 100% Acrylic non toxic anti-corrosive metal primer for use on degreased galvanized steel and rust free, clean dry mild steel.

PRODUCT FEATURES

  • An anti-corrosive primer suitable for use in tropical environments.
  • Suitable for use on degreased galvanized steel and rust free mild steel.
  • Excellent adhesion.
  • Very good flow and leveling.
  • Virtual oduor free.

APPLICATION AREAS

  • Degreased and/or Weathered galvanized steel.
  • Rust free, clean, dry mild steel.

SURFACE PREPARATION

Rusted Metal: Affected areas need to be cleaned backto bright metal by hand after that apply Etching solution

New metal :Surface need to be degreased to remove the manufacturer’s grease protective layer, after that apply Etching Solution

APPLICATION PROCEDURE

  • Apply a generous coat of Rustgaurd metal primer to the area, which needs protection (for very severe cases e. g in very harsh Marine environments two coats of Rustgaurd metal primer is required)
  • Allow to dry for 4-6 hours before recoating with Duracoat Royal High perfomance Acrylic Metal coating.

GENERAL

  • Don’t apply on exterior if it looks like it will rain within 4-6 hours after application.
  • Rust guard is ready for use, should not be thinned. Thinning with water will reduce its hiding power and anti-corrosion protection strength will be imparted.
  • Although the spread rate will vary with porosity and type of substrate, for new uncoated metal surface, it should cover approximately~ 6-8 Sqrm/Ltr.
  • Clean Application equipment with water.

SHADE RANGE

  • It’s available in Red oxide and grey

PACKAGES SIZES

  • It’s available in 1Ltr,4ltr and 20ltr.

Print Friendly, PDF & Email

You may also like...

Leave a Reply

Your email address will not be published. Required fields are marked *

Sign In

Register

Reset Password

Please enter your username or email address, you will receive a link to create a new password via email.